for 4" ID Silicone Hoses

for 4" ID Silicone HosesThis spring loaded T bolt clamp is used on 4" ID silicone hoses. It is recommended in any air to air application or any application using silicone hoses. Spring loaded T bolt clamps assure a firm hold, regardless of the expansion and contraction caused by changes in temperature and pressure. Stainless band and bridge, plated spring, bolt and nut. Trunnion type floating bridge keeps clamp aligned during tightening.

Legs are 10" long

This 4-1/2" to 4-1/2" charge air cooler hose has reinforcing stainless steel rings to help the hose keep its shape and handle more pressure under high temperature conditions

This reducing 4" to 3" charge air cooler hose has reinforcing stainless steel rings to help the hose keep its shape and handle more pressure under high temperature conditions

This reducing insert adapts a 5" ID intake hose to a 4-3/4" OD tube

This short radius 3" 90-degree intake hose is used when you need to make a tight bend when joining two 3" OD tubes

The tight radius is useful if you need to clear a nearby obstruction

Recommended clamps are CT400

8" long version

Thick wall - Recommended clamps are 94100-0300

This reducing hump hose connects 6" OD and 5

This reducing insert adapts a 4" ID intake hose to a 3-1/4" OD tube (or throttle body)

You install it in the end of the 4" rubber elbow or hump hose